The Ultimate in Servo Mounts
To contact us:
Phone: +44(0) 7754901324
NEW Single Servo Control Board
Price List and
There are many servo control boards on the market to-day which can be used for model railway point and signal operation.
Most are for multiple servos and offer all sorts of bells and whistles.
There are also a range of excellent kits available to members of the MERG group which offer a variety of control options.
I believe there is a need for a very simple board that offers easy setup and operation for model railway points or semaphore signals.
This is the reason behind the development of this particular board.
The Single Servo Control Board has a preset slow speed to simulate real life point movement and there is no provision for adjusting the speed. (However they can be supplied with a faster speed on request.)
The two end positions are set very simply by means of a plug in setting box.
A simple single pole on/off switch is all that is required to move the servo from one position to the other.
De Luxe Setting Box
The Setting Box is supplied with a 2m CAT5 cable, but this can be easily replaced by a longer cable if required by simply unplugging the cable and plugging in a longer one.
Note: The Budget setting box is no longer available as it proved difficult to work with.
Do NOT use
Use the cables supplied by Dingo Servo Mounts.
Or another Cat5e straight cable
Note: A RED dot on the PCB indicates that the firmware has been updated to be compatible with the Ultra Micro Servos: HK5330 and HK282A as well as operating normal 9g servos. (HK15178, SG90, etc)
Boards without this dot will not operate the small servos, but will be fine for the normal 9g servos (HK15178, SG90 or similar)